English version
4
ST021 Sweex External 3.5" IDE Storage Solution USB 2.0 with OTB
Introduction
First of all, many thanks for purchasing the Sweex External 3.5" Storage Solution IDE USB 2.0. By means of this external casing you can quickly
and easily connect an additional 3.5" hard disk to your PC or notebook. You can start your own pre-programmed backup procedure by a push of a
button. The external casing has a USB 2.0 connection.
To ensure this product operates correctly, we advise you to carefully read this manual first. If despite this manual you still experience problems during
installation or operation of this product, go to www.sweex.com and look under the heading service & support.
In order to fully enjoy the Sweex External 3.5" Storage Solution, it is important to observe a number of things:
• Do not expose the Sweex External 3.5" Storage Solution to extreme temperatures. Do not place the device in direct sunlight or in the direct
vicinity of heating elements.
• Do not use the Sweex External 3.5" Storage Solution in extremely dusty or moist surroundings.
• Protect the device against powerful shocks or jolts - they may damage the internal electronics.
Hardware installation of the hard disk
In order for the hard disk to operate, the jumper settings must be correct. Jumper settings on the hard disk can differ between computer systems.
In most cases it needs to be set to “Slave” or “Cable select”. Try either setting to find the correct one.
To Next Page
General