ELECTRICAL SYSTEMS
80
SWIFT COMMAND POWER CONTROL SYSTEM
3.6 Common Fault Table
Fault Possible Cause Proposed Fix
No 230 volt
output from
PSU
Connecting lead between the
site and Leisure Vehicle not
connected
Check and connect lead as per 2.3C
RCD switched off Reset RCD as per 2.3D
RCD not operating correctly Check supply polarity; if the RCD continues
to fail contact your Dealer as there is
probably an equipment or wiring fault.
MCB switched off Reset MCB by switching OFF (down
position) then back ON (up position), if the
MCB continues to fail contact your Dealer
as there is probably an equipment or wiring
fault.
No or deficient supply from site Contact site Warden for assistance.
Other fault Contact your Dealer
Reverse
Polarity light is
illuminated on
PSU
Mains Supply reversed? The reverse polarity light is designed to
illuminate when the Live and Neutral supply
has been reversed / crossed over. If the
light illuminates there is a problem with the
site supply or the cable connecting the
supply to your vehicle. The light is designed
to work on UK electrical supplies (where
the neutral conductor is connected to
earth at the sub station). If you are using
your vehicle outside the UK this light may
illuminate when no fault exists. In these
cases consult the site warden for advice.
Generator being used ‘The Reverse Polarity warning light is on
when using my Generator’.
This is a normal side effect when using
some types of generator. Instead of
connecting the neutral conductor to earth,
some generators centre tap the earth
connection making both neutral and live
conductors 110V above earth. This 110V
difference causes the neon polarity indicator
to illuminate. In most cases it is still safe to
use the generator, but please consult the
generator handbook for further information.
To Next Page
Loading...
