71
Equipment Details
MAKING ICE CUBES
Ice cubes are best frozen overnight. At night,
the refrigerator has less work to do and the
unit has more reserves.
1. Fill the ice cube tray
with drinking water.
Only use drinking
water!
2. Place the ice cube
tray in the freezer
compartment.
DEFROSTING
As time goes by, frost builds up on the fins.
When the layer of frost is about 3mm thick,
the refrigerator should be defrosted.
1. Switch off the refrigerator, as described
on page 71 - "Switching off".
2. Remove the ice cube tray and food.
3. Leave the refrigerator door open.
4. After defrosting (freezer compartment and
fins free of frost), wipe the cabinet dry
with a cloth.
5. Use a cloth to mop up the water from the
freezer compartment.
6. Switch the refrigerator back on again.
Warning: The layer of ice must never be
removed forcibly, nor may defrosting be
accelerated using a heat source.
Note: Water thawing in the main
compartment of the refrigerator runs into an
appropriate container at the back of the
refrigerator. From there, the water
evaporates.
POSITIONING THE STORAGE RACK
Dismantling:
1. Loosen the front
and back securing
brackets.
2. Move the storage
rack to the left and
remove it.
To fit the storage rack, the reverse order
applies.
DOOR LOCKING
Open
Close
Park-position/
vent-position
SWITCHING OFF
1. Set energy selector switch (A) to position
"0" (OFF). The appliance is now fully
switched off.
2. Secure the door open by means of the
door stop. The door will be slightly ajar.
This is to prevent mould from forming
inside the appliance.
To Next Page
Loading...
Need help?
General
