75
Equipment Details
MAINTENANCE
• Works on gas components and electrical
installation may only be carried out by
authorised personnel. We recommend to
contact your Dometic Service Centre.
• EN 1949 stipulates that the appliance´s
gas equipment and it’s associated fume
system must be inspected after
installation and a certificate issued.
Afterwards a qualified technician must
inspect according to EN 1949 every two
years and a certificate issued.
It is the user’s responsibly to arrange
for inspections after purchase.
• It is recommended that the gas burner be
inspected and cleaned as necessary at
least once a year.
• We recommend maintenance following an
extended shutdown of the vehicle.
PRODUCT LIABILITY
Product liability of Dometic GmbH does not
include damages which may arise from
faulty operation, improper alterations or
intervention in the equipment, adverse
effects from the environment such as
changes in temperature and air humidity,
which may impact the equipment itself or the
direct vicinity of the equipment or persons in
the area.
Failure : The refrigerator does not work on 230V
Possible cause Action you can take
On-board fuse defective.
No connection to supply voltage.
AES: gas operation despite connection
to the supply voltage?
Fit new fuse.
Establish power connection.
Appliance switches to gas operation due to
insufficient supply voltage (automatically
switches back to 230 V operation)
Failure : The refrigerator does not cool sufficiently
Possible cause Action you can take
Inadequate ventilation to the unit.
The thermostat setting is too low.
There is too much ice on the condenser.
Too much warm food put inside.
Appliance running for a short time.
Check that the ventilation grilles are not
covered.
Turn the thermostat to a higher setting.
Check that the refrigerator door seals
when shut.
Let food cool down first.
Wait several hours, check again.
To Next Page
Loading...
Need help?
General
