70
Equipment Details
Gas faults at "AUTO"- mode
If gas faults occur the operating LED "C"
flashes yellow.
Remedies:
Set the energy selector switch (A) to position
"OFF".
1. Is there any gas in the gas bottle?
2. Is the gas bottle valve open?
3. Is the on-board shut-off valve open?
4. Set the main switch (A) to "on"
The ignition starts again.
If after about 30 seconds the operating
display (C) starts flashing red again, the
gas fault has not been cleared (e.g. air in
the gas pipe).
5. Briefly switch the refrigerator off and then
on again using main switch (A).
To remove air from the gas pipes, repeat
this procedure 3-4 times.
If these actions do not help, please call an
authorised Dometic Service Centre.
Additional functions (RM 7XX5 L - models
only)
• Temperature setting display (D) with 4
LED to indicate the selected temperature
(MIN - MAX)
• LED - dimmer (E) for adjusting the
brightness of the display-LED (only
accessible when door opens)
Underneath the fascia is a knurled knob for
adjusting the brightness (see item E above)
Temperature setting cooling compartment
As shown, you are able to regulate the
temperature of the cooling compartment, if
necessary, by turning rotary knob (B) .
The cooling unit’s performance is influenced
by ambient temperatures.
Tip: Please select the medium setting for
ambient temperatures between +15°C and
+25°C. The unit operates within its optimum
performance range.
STORING FOOD
• Always store food in sealed containers,
aluminium foil or similar.
• Never put hot food into the refrigerator,
always let it cool down first.
• Products that could emit volatile,
flammable gases must not be stored in
the refrigerator.
• Store quickly perishable foods directly
next to the cooling fins.
The freezer compartment is suitable for
making ice cubes and for short-term storage
of frozen food. It is not suitable as a means
of freezing foods.
To Next Page
Loading...
Need help?
General
