Mounting bracket B:
Clean the installation surface using the
provided wet wipe first. Apply the adhesion
promoter to the installation area. Peel off the
3M adhesive tape liner on the back of the
mounting bracket, align the hole of the
mounting bracket with your lock cylinder,
then firmly attach it on your door. Press for at
least 2 minutes to ensure a secure installation.
Tip: If the contact area is small or if you are concerned
about the stickiness of the adhesive tape, you can
use screws to secure the mounting bracket. Refer to
the following pictures to operate.
Adhesion Promotor
Primer/Binder
Wet Wipe
51) —Z Y
09
To Next Page
Loading...
