@ Remove the Anti-Tangle Rubber Brush, pull out the bearings
at both ends, and clean any hair or dirt wrapped around the
brush. You can use the provided small cleaning tool for this.
O Install the Anti-Tangle Rubber Brush back to the robot. You will
hear a clicking sound once it is correctly installed. Make sure bot
ends of the brush are inserted into the robot's pegs, and then
cover it with the brush cover.
f' Important:
• Wipe off the dirt on the Anti-Tangle Rubber Brush with a damp cloth. If the
brush is soaked, dry it thoroughly and avoid direct sunlight.
• Do not use corrosive cleaning liquids or disinfectants to clean the Anti-Tangle
Rubber Brush.
16
ide Brush
Remove the Side Brush.
Clean the Side Brush and its mounting shaft, then reinstall it.
To Next Page
Loading...