10
bt
bt cfG
Printing the diameter or center in
diameter mode.
Option selection for printing in
diameter mode:
• Dia, center
• Dia
• Center
Bluetooth
®
modes • On
• O
• Reset
• MAC
Bluetooth
®
proles • Simple
• Pair
• HID
FCT key
Setup Function Settings
sequence
The FCT button as well as the external contact (EXT) can be set to perform
dierent functions related to the type of measurements in progress.
The dierent settings are:
FCT0 mm ↔ INCH : change the unit of the active measurement
FCT1 data output : sends displayed value to RS232 and USB
FCT2 Zero setting : zero setting
FCT3 preset recall : preset value recall
FCT4 surface ↔ Dia : toggles between surface and diameter mode
FCT5 Surface ↔ Min : toggles between surface and Min | Max mode
FCT6 Clear Min | Max : initializes Min and Max value to probe position
FCT7 Ref 1↔ Ref 2 : toggles ref1, ref2
FCT9 measure ↔ Di : dierence between the 2 last measurements
FCT10 BT ON ↔ OFF : Activate, deactivate the Bluetooth
®
module
(even if a preset has been entered)
ou Bluetooth
®
To Next Page
Loading...
Need help?
General
