9. The best way to ride off
13
• Turn on the turn signal light before moving, and make sure no vehicle is coming from behind. Then, ride
off.
THE CONTROL OF THROTTLE VALVE HANDLE
Acceleration : To increase speed. When riding
on an inclined road, turn the throttle
valve handle slowly to allow the
engine to output its power.
Deceleration : To decrease speed.
PARKING METHOD
When approaching the parking lot:
1. Turn on the turn signal light early, and pay attention to the vehicles in front, from rear, left and right,
then take the inner lane and approach slowly.
2. Return the throttle valve handle back to its original position, and apply brakes in advance. (Brake light
comes on when braking to warn drivers of vehicles behind.)
When stopped completely:
1. Press the turn signal switch back to its original position, and turn the ignition switch key to “ ”
position to shut off the engine.
2. Get off the scooter from left side after the engine has been stopped, and select a parking place where
the scooter will not interfere with traffic and the ground is level, then put the scooter’s main parking
stand down.
3. Hold the steering handle with your left hand, and hold down the front end of seat or hold the parking
handle on the lower-left side of seat with your right hand.
4. Press the main parking stand with your right foot, put down the main parking stand firmly on the
ground.
To remind you:
Lock the steering handle and remove the key after parking to prevent the scooter from being stolen.
Use
side stand only at irregularity surface or when temporary parking. When using side stand, make
sure to turn the handlebar to left end in order to increasing the stability of parking.
CAUTION:
Always park your scooter in a safe place where it will not interfere with traffic.
To Next Page
Loading...
