5. Removal & Installation of Engine
5-10
Removal of Engine Mount Bushing
If engine hanger frame and the cushion rubber of
rear cushion bushing are damaged. Then use the
bushing remover / presser, •28mm & •20mm, to
press the bushing out and replace it with new one.
Engine hanger bushing: • 28mm
Rear cushion bushing: • 20mm
Pressing out
Place the detent section of the bushing remover
toward the bushing, and drive both the pressing
ring and bolt in to press the bushing out.
Special Service Tools:
Crankcase bushing remover SYM-1120310
Crankcase bushing remover SYM-1120320
Pressing In
Place the flat section of the remover toward the
bushing, and then drive the bushing, pressing ring,
and bolt in to install the bushing.
To this chapter contents
To Next Page
Loading...
