2. Maintenance Information
2-3
Engine Oil
Turn off the engine, and situate the motorcycle
vertically by main stand.
Check the oil level with oil filler plug.
Do not screw the oil filler plug into the engine
when checking.
If oil level is nearly low level, pour in the
recommended oil to the upper level.
Oil Change
Caution
Drain oil as engine warmed up to make sure oil
can be drained smoothly and completely.
Place an oil pan under the engine, and remove the
oil drain bolt.
After draining oil, always replace the
washer/gasket on the drain plug.
Tighten the oil drain bolt.
Torque value: 3.5~4.5kgf-m
Pour in the oil (viscosity SAE 10W-40)
Recommended oil: LIQUI MOLY
Engine oil capacity:
Disassembly 1400c.c.
Replacement 1200c.c.
Screw the oil filler plug; start the engine and run it
for several minutes.
Turn off the engine, and check the oil level again.
Check if the engine oil leaks or not.
Engine Oil Strainer
Drain the engine oil.
Unscrew the oil filter cap and remove the oil
strainer and the spring.
Clean the oil strainer.
Always replace the O-ring when disassembled.
Install the oil strainer and the spring.
Tighten the oil filter cap.
Torque value：1.3~1.7kgf-m
To this chapter contents
To Next Page
Loading...
