2. Maintenance Information
2-11
Brake Lining Wear
The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
It is not necessary to remove brake hose when
replacing the brake lining.
Remove the brake clipper bolt, and take out the
clipper.
Caution
Do not operate the brake lever after the clipper
removed to avoid clipping the brake lining.
Pry out the brake lining with a flat driver if lining is
clipped.
Remove 2 cotter pins
Caution
In order to maintain brake power balance, the
brake lining must be replaced with one set.
Remove the brake pad shafts and pads.
Lining
Brake caliper
Brake disk
2 bolts
Cotter pins
To this chapter contents
To Next Page
Loading...
