3. LUBRICATION SYSTEM
3-3
Engine Oil
Turn off engine, and park the motorcycle in flat
surface with main stand.
Check oil level with oil dipstick
So not screw the dipstick into engine as
checking.
If oil level is nearly low level, fill out
recommended oil to upper level.
Oil Change
Caution
Drain oil as engine warmed up so that make sure
oil can be drained smoothly and completely.
Place a oil pan under the motorcycle, and remove
oil drain bolt.
After drained, always replace the washer/gasket.
Install oil drain bolt.
Torque value：1.9~2.5kgf-m
Engine Oil Strainer Clean
Drain engine oil out.
Remove oil strainer and spring.
Clean oil strainer.
Always replace O-ring when disassembled.
Install oil strainer and spring.
Install oil strainer cap.
Torque value：1.9~2.5kgf-m
Add oil to crankcase (oil viscosity SAE 10W-40)
Recommended LIQUI MOLY Racing 4T
10W-40 API SL oil.
Engine oil capacity: 1.2 L when replacing
Install dipstick, start the engine for running
several minutes.
Turn off engine, and check oil level again.
Check if engine oil leaks.
Drain bolt
Oil strainer cap
To this chapter contents
To Next Page
Loading...
