4. Fuel Injection System
4-51
Data stream (1/3)
The screen showed the ECU captured by the engine of the state immediately.
The following data for the benchmark idling state:
Š Engie SPD--- RPM (Idle:1550~1750) ‰Engine idle speed
Š FAULT NO.-------- (Normal:0) ‰Fault code number
Š BATT. VOLT---- V (Above 12V) ‰Battery voltage
Š FUEL PUMP--------- (Idle:ON) ‰Fuel pump actuator state
Š MAP------------ kPa (Idle:32~38kPa) ‰Manifold pressure
Š TPS position------ % (Idle:﹤ 1.5%) ‰Throttle opening
Š TPS position---- V (Idle:0.58~0.62) ‰Throttle sensor voltage
Š O
2
SENSOR---- mV (Idle:50~200mV) ‰O
2
sensor voltage
Š O
2
HEATER--------- (Idle:﹥ 3500rpm=ON) ‰O
2
heater actuator state
Š ENGINE TEMP-- ƒC (Stable:85~95ƒC) ‰Engine temperature (cooling water temperature)
In the "DATA STREAM" of the screen use "•" "•" button to move the left side of the project "‰"
symbol selected items, press the "ENTER" buttom lock of the project, and press the "F4" button
showed that the wave of projects.
Able to use "‘ left" and "right ’" button, can transform View wave numerical size.
Numerical analysis of images (1 / 3), the waveform can be displayed as shown in the following items:
Engie SPD
BATT. VOLT
MAP
TPS position %
TPS position Voltage
O
2
SENSOR Voltage
ENGINE TEMP
To this chapter contents
To Next Page
Loading...
