11. AC. Generator / Start Clutch
11-6
Remove the rollers, spring caps, and springs of
clutch on the one way clutch that located on the
back of flywheel.
Check each roller and plug for wear or damage.
Install rollers, plugs and springs.
Installation
Install the components in the reverse
procedures of removal.
Caution
Torque value: 1.0~1.4 kg-m
Installation
Install reduction gear shaft and reduction gear.
Install starting clutch gear onto crankshaft.
Tape a tightening tape onto the thread of
hexagon bolt.
Spring cap
Rollers
Springs
To this chapter contents
To Next Page
Loading...
