8. V-Belt Drive System / Kick Starter
8-12
Clutch Block Replacement
Remove snap and washer, and the remove clutch
block and spring from driving plate.
Check if spring is damage or insufficient elasticity.
Check if shock absorption rubber is damage or
deformation. Replace it if necessary.
Apply with grease onto setting pins.
Apply with grease onto setting pins. But, the
clutch block should not be greased. If so, replace
it.
Install new clutch block onto setting pin and then
push to specified location.
Caution
z Grease or lubricant will damage the clutch
block and affect the block’s connection
capacity.
Install the spring snap into groove with pliers.
Clutch block
Shock absorption rubber
Snap ring
Spring
Spring
Drive plate
Clutch block
Setting pin
Shock absorption
rubber
To this chapter contents
To Next Page
Loading...
