9. Final Drive Mechanism
9-8
Final Drive Mechanism Reassembly
Install drive shaft.
Special tool:
Drive shaft puller SYM-2341110- HMA RB1
Drive shaft socket & oil seal driver (25*40*8)
SYM-9120200-HMA
Clutch nut wrench SYM-9020200
Apply with grease onto drive shaft oil seal.
Install the oil seal to left crankcase.
Special tool:
Drive shaft socket & oil seal driver (25*40*8)
SYM-9120200-HMA
Install 2 dowel pins & new gasket.
Install counter shaft and final shaft into the gear
box cover.
Install the gear box and tighten the bolts (7 bolts).
Torque value: 2.6~3.0kgf-m
Install driven pulley / clutch outer / belt.
Install movable drive face, drive face and left
crankcase cover.
Install rear wheel.
Add gear oil.
Gear oil quantity: 180c.c.
Drive shaft puller
Drive shaft and
seal install socket
Clutch nut wrench
Oil seal driver
To this chapter contents
Dowel pins
Final shaft
Counter shaft
Drive shaft
To Next Page
Loading...
