Sym RV 250i - Start Clutch

10. AC. Generator / Start Clutch
10-6
Start Clutch
Start Clutch Inspection
Remove start clutch driven gear.
Check the gear for wear or damage.
Measure the ID and OD of the start clutch driven
gear.
Service Limit: ID: 25.050 mm
OD: 42.100 mm
Check the starting reduction gear and shaft for
wear or damage.
Check each roller for wear or damage.
Install start clutch driven gear onto one way clutch.
Hold flywheel and rotate start clutch gear.
The start clutch gear should be rotated in C.C.W
direction freely, but not C.W direction. (View as
shown in this figure.)
ID
OD
To this chapter contents