EasyManua.ls Logo

SYNCRO KT-331P - Page 3

SYNCRO KT-331P
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
海外
使用住院节晶;:::注意
1
模型用
j
具体比使用
l
,tJ:
W~<
tt
主\,\.
本就明豁』
ζ
起戴在机
τ
吨黯品路、日本国内@雷波法飞用途古守模型用
限定在机
τ
指'?*节。
2
海外
T
使用苦晶膝
0);:::
注意
本事且品奄海外"t'使用..晶塌合、使用..蒂固
(J)
需波法?器可在机
τ
\,
\t.;:
\,
飞e:使用节串1:
e:
t
在?古lI<tl:
fv
被选、器曹毒草、部品交换
iJ
tc
壤合
(J);:::
注意
本斟品在弊社以外?哉造、翻整、部晶交换怠
/:(J)
手护主目
Ãð
机元蠕舍、一切由王寅任奄氮
L
飞力、,,",lI<节。
'Expo
ation
precautions
When
Ihis product is exported Irom Japan, ils use is
10
be approved by Ihe Radio
law
01
Ihe counlry
01
des
nation.
咽。
di
百四
tlon
,叫
ustme
时,
and
repla
拥而
ent
01
阴阳
THE
FOLlOWING
STATEMENT APP
Ll
ES TO THE RECEIVER (Ior U.S.A.)
This devioo complies wilh
parl15
01
Ihe FCC rules. Operalion is
subj
酣~
10
Ihe lollowing two condilions
Thisd
酣睡
may
nol
"se
harmlul inlerlerence, and
(2) This
de
ce
must
蹦蹦
1
any
inlerfe
nce
rece!v
时,
includin
inlerfe
nce
Ihat may cause
undesir
,酬。
per
lon.
'osho
is not responsible
1m
unaulhorized
modilica
on
,叫
uslmenl
and replacemenl
01
par
悟。
Ilhis
product.
'No
part
01
Ihis manual may
be
rep'oduced in any lorm wHhoul p'io, permission
3
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.