To Next PageTo Next Page
Need help?Do you have a question about the Synergy Convertible Crib and is the answer not in the manual?
Warnings about cords, strings, loose fasteners, and blind cords.
Information about soft bedding, pillows, padding, and plastic film.
Specifies minimum and maximum mattress dimensions for safe fit.
Actions to take when child can pull to stand, and when to stop using crib.
Avoid placing cords or similar items near the crib or near windows.
Mattress must be no thicker than 15 cm and leave no gap larger than 3 cm.
Do not place pillows, comforters, or soft mattress in the crib.
Align Right Front Leg (2) and Right Rear Leg (5) to Side Panel (8).
Insert Bolts (B) into holes and Barrel Nuts (C) from bottom.
Tighten Bolts (A) into Barrel Nuts (C) using Allen Key (D).
Align Left Front Leg (3) and Left Rear Leg (6) to Side Panel (8).
Insert Bolts (B) into holes and Barrel Nuts (C) from bottom.
Tighten Bolts (A) into Barrel Nuts (C) using Allen Key (D).
Align side panels to the Headboard (4) as shown.
Insert Bolts (B) into Side Panels (8) and Barrel Nuts (C) into Headboard (4).
Tighten Bolts (A) into Barrel Nuts (C) using Allen Key (D).
Attach Mattress Support Panel (7) to Headboard (4) and Side Panels (8).
Insert Bolts (E) and tighten using Allen Key (D).
Details on Lowest, Mid, and Highest positions for mattress support.
Align the Footboard (1) to the Side Panels as shown in the diagram.
Insert Bolts (A) into holes and Barrel Nuts (C) from bottom.
Ensure alignment is correct and panels are firm before use. Do not overtighten.
Failure to follow warnings can cause serious injury or death from entrapment or strangulation.
Do not place bed near windows with blind or drape cords.
General| Brand | Synergy |
|---|---|
| Model | Convertible Crib |
| Category | Indoor Furnishing |
| Language | English |
