305-112 Elevator Tail Servo Mount
High Quality Digital 760us Tail Servo (Not Included)
Recommended - Futaba BLS256
100-268 M2.5x8 Socket Head
106-115 Servo Hold Down
107-104 Pivot Ball 2mm
100-252 M2 Nylock Nut
Note - Servo horn will need to be trimmed
in order to avoid interference with gyro
sensor mount.
Important - Pivot ball should be located at
16mm from center of servo horn. This is important
for proper servo resolution.
Tail Servo Mount
Page 14
WWW.SYNERGYRCHELICOPTERS.COM
To Next Page
Loading...
