How should the CO1224T unit be wired
to a fire or security control panel?
Per NFPA 720, CO detectors must be wired on a non-fire
zone. No other fire or intrusion device shall be installed
on the CO zone to prevent the CO alarm from being reset
while it is monitoring low-level CO accumulation. This
could cause a dangerous level of CO to be present for an
unsafe amount of time.
Can the CO1224T be functionally tested?
Yes, in fact the CO1224T is the first system CO detector
that can quickly and easily be tested using canned carbon
monoxide.
Is canned carbon monoxide safe to use?
Yes. Carbon monoxide is harmful when high levels are
present for extended periods of time. The concentrations
of gas found in canned CO products will not cause symp-
toms of harm when dispensed for short amounts of time.
When using canned CO, please read and follow all manu-
facturer’s instructions.
Does the RealTest feature take a lot of
time?
No. The RealTest feature on the CO1224T allows the
installer to easily test the detector in less than one minute.
How can I find out how to use the
RealTest feature on the CO1224T?
Visit systemsensor.com/co to view a how-to video on the
RealTest process and to learn more about the CO1224T
carbon monoxide detector.
What is the warranty for the CO1224T?
System Sensor warrants the CO1224T to be free from
defects in materials and workmanship under normal use
and service for a period of three years from date of manu-
facture. Please see the installation manual for complete
warranty information.
To Previous Page
Loading...
Need help?
General
