Agency Listings
MOD400R
Field Sensitivity
Test Module
The MOD400R fulfills the NFPA 72 requirement for
detector sensitivity testing.
Features
• Compatible with all System Sensor direct wire and plug-in smoke
detectors (100, 200, 300, 400, and 500 Series), or System Sensor
DH100, DH200, DH400, and DH500 Series duct smoke detectors,
ionization or photoelectronic
• Fulfills NFPA 72 requirement for field sensitivity testing
• Interfaces with standard DC voltmeter or multimeter
• Low battery diagnostic: when connected to a voltmeter, the
MOD400R monitors its own battery voltage
• Quickly tests sensitivity of detectors without putting system into
alarm
The MOD400R Field Sensitivity Test Module is designed to
check the sensitivity of System Sensor 100, 200, 300, 400, and 500
Series conventional detectors or System Sensor DH100, DH200,
DH400, and DH500 series duct smoke detectors. The test module can
be connected to any DC voltmeter (meter movement of 10K ohms/v
or greater) to obtain a reading which correlates to the detector’s
sensitivity range.
S2522 OX5A4.AY
To Next Page
Need help?
General
