FABRIC
POSITION OF
THERMOSTAT CURSOR
STEAM SETTING
POSITION
COTTON
WOOL
SILK
SYNTHETIC
Polyester, Acetate,
Acrylic, Nylon
MIN
DRY
●●●
●●
●
●
= STEAM ZONE
Fabrics and ironing temperatures:
• Your iron heats up quickly: begin by ironing fabrics that require a low temperature, then go on to
those requiring a higher temperature;
• If you reduce the temperature, wait until the indicator light comes back on before ironing again.
• When ironing fabrics with mixed fibres, set the temperature to the most delicate of the fibers.
H
- When steam or dry ironing, press several times on the Spray Button to moisten fabrics (H)
and to remove stubborn creases.
- Make sure that there is water in the reservoir before using this feature.
What temperature and which steam setting to use ?
Moistening the fabric (Spray)
LINEN
MAX
MAX
- Press the Burst of Steam button ( ) from time to time (I).
- Wait a few seconds before pressing the button again.
I
- The electronic system automatically cuts off the electric power and the Auto Shut off
indicator light blinks if the iron remains immobile on its heel for more than 8
minutes, or in a horizontal position for more than 30 seconds.
- To restart the iron, just shake it gently until the indicator light stops blinking.
Note : When the Auto Shut off security feature is on,
it is normal that the thermostat indicator light to be off.
M
Obtaining more steam for removing wrinkles
(depending on the model)
Vertical steam ironing (depending on the model)
Auto Shut off security feature
(depending on the model)
J
K L
J
Recommendations:
- Hang the garment on a hanger and hold the fabric slightly taut with one
hand.
- Set the thermostat control on MAX (J).
- Press the Burst of Steam button ( ) repeatedly (K), moving the iron
from top to bottom (L).
- Hold the iron a few inches from the fabric to avoid burning delicate
fabrics.
To Next Page
Loading...
