TECHNICAL SPECIFICATIONS
Input Impedance@1KHz Higher than 1M Ohm
Output Impedance@1KHZ Lower than 1K Ohm
Power supply 12V DC (T-Rex FuelTank)
Minimum Power supply Voltage 10,8V DC
Maximum Power supply Voltage 12,5V DC
Current Draw @ 12V DC 330mA
Maximum Input signal Vp/p Adjustable
External connectors Input Jack. Output Jack (R),
Output Jack (L), 12V DC jack
Controls On/Off, Level, Mode, Mix, Decay,
High cut, Input Gain
Pedal size incl. knobs (W x H x D) 100 x 55 x 120 mm / 3,9 x 2,2 x 4,7 inch
Weight
(excl. battery and packaging)
0,380 kg / 13,4 oz
ROOM-MATE CONTROLS
MODE is where it all starts, and you can choose between the following 4 pre-
sets:
SPRING – a short spring reverb with low decay settings, a long spring reverb
with high decay settings.
ROOM – classic room reverb for an adjustable touch of live vibe.
HALL – gorgeous concert hall reverb you can adjust as you like.
LFO – reverb embellished with chorus, perfect for acoustic guitar.
DECAY controls the length of your reverb trail. Keep it down for a more subtle,
smaller-room eect. Turn it up to sound gigantic!
MIX controls the blend of clean signal and reverb.
LEVEL sets the overall volume of your signal out to your amp.
The HICUT knob lets you turn down the high end for a more vintage tone.
GAIN lets you turn down the signal coming into your Room-Mate. This is useful
for eliminating input overload distortion when you position your Room-Mate
at the end of a chain of eects or when you use it in an eects loop, where the
signal from you amp is very loud.
The ON/OFF indicator light at the top centre of your Room-Mate changes
colour from green to yellow/red when the input signal is too high.
To Next Page
Loading...
Need help?
General