T2 LUKE II - Install the Keypad Lighting Assembly

Luke
®
II Keypad Lighting Installation Guide
5
T2 Systems, Inc. | T2systems.com
11. Since the cast is an aluminum-alloy, it does not need the zinc-rich paint. However, a thin
coating of marine grease is recommended. Carefully apply the marine grease to the three
holes in the front cast using a Q-tip.
Install the Keypad Lighting Assembly
Tool Required
 Phillips screwdriver
Parts
 1x Keypad Lighting Module
 1x Cable, Keypad Lighting
 1x Diffuser, Keypad Lighting