Red light=charging Green light=Charging completed
Charger will automatically stop charging the battery when charging is
completed. It is ok to leave tool on charger continually
NOTE! A battery pack that has been unused for a while or never been
charged must be charged before reuse or first use.
CAUTION! Do not charge a battery for a second time in close succession.
There is a danger of overcharging the battery pack.
Switching on and off / Setting the speed range
Switching on / Setting the speed range:
Set the On / Off switch
Press the speed control between 1 and 3
Press switch 2 seconds, the tool will turn off
Accessories
Polishing wheels: Use to polish work-pieces made of metal and plastic.
Use one of the provided mandrels to assemble.
Diamond bits: For fine detail work, engraving, carving, touch-up and
finishing. Use on wood, jade, ceramic, glass, hardened steel, semi precious
stones and other hard materials. Bits are covered with diamond particles.
Grinding stones: Use for surface treatment of metal parts, cast-metal parts,
welding seams and for the removal of rust. Different shapes are available.
Cutting-off wheels: Use to cut work-pieces made of metal, plastic, wood or
stone. Use one of the provided mandrels to assemble. The cutting-off wheel
only cuts with the outer edge.
- 05 -
To Next Page