Tactacam Fish-i User Manual

WWW.TACTACAM.COM
FISHI QUICK START GUIDE
1. Push the Rec/Power button. You will
feel the camera vibrate 2 times and see a
blinking green light around the
Rec/Power button. The green LED must
be blinking for the camera to be recording.
The process takes approximately 3 seconds.
NOTE: If light does not begin to ash,
make sure your SD Card is installed,
formatted, and not lled with videos.
2. (GREEN MODE ONLY) Push the power
record button when the camera is recording
in loop mode it will mark and save that video
and continue to record.
3. Pause your recording in (GREEN LOOP
MODE) push the mode button. The camera
will vibrate 1 time and the green light will go
solid around the rec/power button.
Pause your recording in (BLUE or LIGHT
BLUE MODE) by pushing the Rec/Power
button. The camera will
vibrate 1 time and the green light will go
solid around the rec/power button.
4. With the camera paused, change the
modes by pushing the mode button.

Tactacam Fish-i Specifications

General

Brand	Tactacam
Model	Fish-i
Category	Fishing Equipment
Language	English