2. Slide the 2 supplied spacers (T2805.11 and T2805.12) to the back of the axle.
3. Place the Body, with the black ring, and the cassette back in position.
Specifications
Wireless Protocol:
Frequency range
RF Output Power
Temperature Range
Transmit Range
Power supply
Bluetooth 4.0 & ANT+
2400-2483,5 MHz
0 dBm (typical)
Operational -20 °C to + 55 °C
10 m
Only use supplied power cord
FCC and IC Declarations
Your device contains a low-power transmitter. When device is transmitting it sends out Radio Frequency (RF) signals.
Compliance statement (part 15)
This device complies with Part 15 of the FCC Rules and to the licence-exempt RSS standards(s) of Industry Canada. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Warning (part 15.21)
Changes or modifications not expressly approved party responsible for compliance could void the user’s authority to operate the equipment.
Unauthorized modification or attachments could damage the transmitter and may violate FCC regulations.
CE Declaration of Conformity
Tacx bv hereby declares that this NEO 2T Smart (T2875) conforms to the essential requirements set out in the Council (European parliament) Directive
and other relevant provisions of directives RED 2014/53/EC and RoHS 2011/65/EU. A copy of this declaration is available on the Tacx website:
www.tacx.com
ROHS
This product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There
is a separate collections system for these products.
Tests have revealed that the unit will not overheat, even when subject to extreme use. However, when subject to prolonged and intensive use, the
enclosure around the brake may become very hot. Always allow the brake to cool down after use before touching it.
Ensure not to drop the brake during assembly as this can lead to an imbalance which may cause vibration.
Never open the brake unit as this may cause damage.
Inspect the nuts and bolts on the trainer on a regular basis, and retighten if necessary.
Perspiration moisture and condensation can harm the electronics. Do not use the trainer in damp areas. Incorrect use and/or maintenance will
void the warranty.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack
or experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved.
Children are not to play with the Tacx trainer without supervision.
This device is not designed for industrial, commercial, or medical applications.
Do not expose the product to water or moisture.
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
In case of not using the trainer, switch it off and unplug the mains.
Keep the trainer in a dry room at room temperature.
To Next Page
