To Next PageTo Next Page
Need help?Do you have a question about the TAG MCLAREN AUDIO 100P and is the answer not in the manual?
General| Brand | TAG MCLAREN AUDIO |
|---|---|
| Model | 100P |
| Category | Amplifier |
| Language | English |
Details the conservative power rating and high-quality output circuitry for robust performance.
Details the rated and typical power output into different impedance loads.
Identifies the BFA socket loudspeaker terminals on the rear panel.
Explains how to connect loudspeakers using BFA plugs or bare wire.
Details connecting a preamplifier using screened audio cables.
Guides on connecting the unit to an AC supply outlet for power.
Describes the left and right inputs accepting output from a high-quality preamplifier.
Describes the four pairs of loudspeaker terminals and their purpose.
Details using BFA plugs, spade connectors, or bare wire for connections.
Explains the basic method of connecting one cable per driver to each loudspeaker.
Describes running separate cables for high and low frequencies to drivers.
Explains using separate amplifiers for high and low frequency drivers.
Details an alternative bi-amping setup for amplifier proximity to loudspeakers.
Mentions connecting separate cables for high, middle, and low frequencies.
Lists the rated power output into different impedance loads (8, 4, and 2 Ohms).
