INSERT COTTON
Carefully guide a cotton strip through the winding.
Shorten the cotton on both sides. It should stick out
about 1.2 - 1.5 cm on each side.
The ends of the cotton are loosely guided
down the sides. Do not stuff in it!
The cotton should cover the liquid channels from the inside.
The cotton should now be slightly pre-moistened.
TANK BEFÜLLEN
There is a mark on both the top cap and the top of the tank.
To open the tank, these two markings must be
placed one below the other.
Now the top cap can be removed from the tank.
Liquid can now be filled in via the two filling openings.
Then the top cap is put back on.
By turning the top cap the tank is locked.
WARNING
•
Always make sure that the tank is filled sufficiently to avoid dry hit.
•
Make sure that no liquid gets on your skin, otherwise wash these areas thoroughly.
• The tip of the bottle must not be too thick to be able to refill.
• Be careful not to lock the top cap too tightly. A slight twist is enough.
To Next Page
Loading...