8
CARE AND MAINTENANCE
If the speargun is used correctly minimum care is needed.
1. After each use rinse speargun and spear with large amount of fresh water, focusing on the
barrel and power adjusting rod. Wipe spear dry, preferably with oiled rags. Make absolutely
sure that there is no sand left on the spear and barrel, as with the presence of sand it is
possible to damage barrel and vacuum rubber ring.
2. Always check your hand loader for damage; replace it with a new one if necessary.
3.If your spear is bent then straighten it or replace it with a new one.
4.We recommend to store and carry the spear with caps on (Pos. 1 Picture 9)
5. Store your gun in dark, cool place.
6. Take care that adjusting rod is set at maximum power while storing.
7. For long storage half of the air should be released.
8. Annual maintenance, including replacement of lubricating oil is a must.
9. Before using after long-term storage we recommend:
- Fill the barrel with 1 cm³ of oil;
- Insert the spear into the barrel; fix the line slide with the holder.
- Lean the tip against firm surface and imitate the process of loading without
hooking the piston.
10. When your speargun needs repair or maintenance contact the manufacture or service
centers.
Picture 9
1.
9
Spears supplied in Ж8mm, Ж7mm and Ж6,5mm
in two mods: threaded and with spear tips.
Polyurethane seal at the spear tang being fixed at the back excludes jamming of
line ethe slid and allows reduction of the sound volume as compared
.to the alternative design solutions
Sharp spear tip allows
spiercing the scale of big fish
at large distances
Spear caps make transportation and storage of spear and
line more convenient
Cap
Spears
TAIMEN tip
MARLIN tip
Increased piercing power,
special grinding helps put
the spear into rotation
pierces the scales and bones of big fish easily
SPEAR SIZE TABLE
Spear with tip,
mm
340
440
540
640
800
940
300
400
500
600
760
900
Gun model
PVM400
PVM500
PVM600
PVM700
PVM850
PVM1000
Threaded spear,
mm
To Next Page
Loading...