TN-2115-SR
25 June 2013
Page 2 of 6
3. Problems fixed
3.1 WebUI: No error given indicating why VOX and E-Line PTT cannot both be selected
Tait reference:
TIMS00097843
When attempting to activate the voice detection or E-line PTT options, if the
other was already selected the page could be saved but the change was not
accepted, and no error was given indicating why.
Solution
Now, when PTT is enabled, the VOX detection automatically gets set to
disabled. If VOX detection is enabled, then PTT automatically gets disabled.
Both can be disabled simultaneously.
3.2 WebUI: Clicking Save multiple times directed user to another page
Tait reference:
TIMS00097849
If the user clicked Save a number of times before the status page was
loaded, the user interface navigated to a different page.
Solution
After editing and clicking Save, the button is now
greyed out and disabled so
that the user is not able to click on it again until the Edit button is used to
make more changes.
3.3 Initial digital output level showed wrong values on WUI
Tait reference:
TIMS00101453
The initial pin level for Digital output pins were not matched with the
information on the WUI. After being set, the WUI showed correct information.
Solution
Fixed to set the digital output level as shown on WUI.
3.4 E&M lines active level configurations were incorrect
Tait reference:
TIMS00101059
Line level levels have now been set to active low in the WUI.
3.5 Some CCTM commands showed two prompts
Tait reference:
TIMS00100997
Some CCTM commands showed two prompts and sometimes one is sent
before it's available.
This might be the reason for missing some CCTM commands.
Solution
In CCTM, the prompt will now only show if the CCTM state is not delayed.
3.6 WebUI: IP addresses could be entered and displayed as 192.168.00001.00001.
Tait reference:
TIMS00097851
IP addresses were not reformatted before being displayed; leading zeros
re not omitted.
Leading zeroes are now stripped by the node before validation.
To Next Page
Loading...