- 6 -
2.6 Exchange of a recording paper
(1) Remove the front cover, up the paper
cutting plate, slide the paper feed lever
in the direction of rear.
(Ref. Fig.1)
(2) Set the roll paper to the holder by
pressing a paper guide to left side.
(Ref. Fig.2)
Note:
paper detection sensor is at the
middle-left of the holder, and is
weak against a shock. Therefore, be
careful to do not damage it when
setting the roll paper.
(3) Pull out the end of paper upwards
from under the rubber roller.
(Ref. Fig.3)
Fig.1
Fig.2
Fig.3
①
②
To Next Page