www.aebikes.com.au
|
sales
@
aebikes.com.au
|
page 020
TALARIA STING TL3000 ERROR CODES & SOLUTIONS
ITEM
ERROR CODES
(MX VERSION)
ERROR CODES
(L1E VERSION)
DESCRIPTION ERROR ANALYSIS SOLUTIONS REMARKS
1 E01 00001 Protection IC error.
The inner
communication of the
chip is disconnected.
Re-start the bike.
If the error code is still
showing on the dash,
please send the bike to
the nearest dealer to
inspect and repair.
2 E02 00002
Battery cell
connection wire
disconnected.
The connect wire
for cells are not well
welded, cause the
welding spot loose,
fall off, or connection
wire poor contact.
Re-start the bike.
If the error code is still
showing on the dash,
please send the bike to
the nearest dealer to
inspect and repair.
3 E03 00003
Voltage of battery
cells are not
balanced.
The difference of
battery cells is more
than 500mV, this
error code will display
on the dash.
Re-start the bike.
If the error code is still
showing on the dash,
please send the bike to
the nearest dealer to
inspect and repair.
4 E04 00004
Battery capacity
measurement error.
Don't have this error
for STING's battery.
Just a default setting
error.
5 E05 00005 Storage error.
Record devices
detected failure.
Re-start the bike.
If the error code is still
showing on the dash,
please send the bike to
the nearest dealer to
inspect and repair.
6 E06 00006 Time display error.
Time device
detected failure.
Re-start the bike.
If the error code is still
showing on the dash,
please send the bike to
the nearest dealer to
inspect and repair.
7 E07 00007 Discharge MOS error.
Discharge circuit
detected failure.
Re-start the bike.
If the error code is still
showing on the dash,
please send the bike to
the nearest dealer to
inspect and repair.
8 E08 00008 Charge MOS error.
Charge circuit
detected failure.
Re-start the bike.
If the error code is still
showing on the dash,
please send the bike to
the nearest dealer to
inspect and repair.
9 E09 00009 Over charge error.
1. Charging voltage
is higher than single
battery cell's over
charge protection
voltage 4250mV.
2. Misinformation of
BMS .
Re-start the bike.
When this error code
display on dash, will
not affect the riding, but
cannot charge. After the
re-start, if the error code
still display on dash,
please send the bike to
the nearest dealer to
inspect and repair.
To Next Page
Loading...
