Need help?Do you have a question about the Tallas Pumps D-BOOSTi Series and is the answer not in the manual?
General| Brand | Tallas Pumps |
|---|---|
| Model | D-BOOSTi Series |
| Category | Water Pump |
| Language | English |
Lists liquids suitable for pumping, emphasizing clean, non-aggressive substances free from solid bodies.
Details electrical specifications for the 127V version, including power, voltage, frequency, and capacitor values.
Provides hydraulic specifications for the 127V version, such as flow rate, head, pressure, and suction depth.
Specifies cable type, motor protection, insulation class, liquid temperature, and particle size for the 127V version.
Details electrical specifications for the 230V version, including power, voltage, frequency, and capacitor values.
Provides hydraulic specifications for the 230V version, such as flow rate, head, pressure, and suction depth.
Specifies cable type, motor protection, insulation class, liquid temperature, and particle size for the 230V version.
Store in a dry covered place, free from vibrations and dust. Keep in original packaging until installation.
Avoid subjecting products to needless impacts and collisions during transport.
Adhesive plate on packaging indicates total weight and dimensions for planning.
Critical safety instructions including handling, operation, and environmental protection.
Do not subject the motor to excessive starts/hour; it is strongly recommended not to exceed 20 starts/hour.
The diameter of the suction pipe must be greater than or the same as the diameter of the pump inlet.
Ensure correct mains voltage, earth connection, and use appropriate power cable length and type.
Check pump priming by filling with clean water through the filling hole to lubricate the mechanical seal.
Provides a general overview of the electronic control interface and its functions.
Explains the pressure indicator LEDs and their function in showing system pressure changes.
Explains how the pump operates in automatic and manual modes, including start-up and stop conditions.
Describes the pump's priming process, potential issues, and dry run alarms.
Details how to reset alarms indicated by the red 'ALARM' light and what happens after reset.
Explains the function of the power ON/OFF indicator LED on the pressure LED bar.
Describes the blue 'PUMP ON' indicator light and when it should be illuminated.
Details the different alarm indications (steady red, slow pulse, quick flashes) and how to reset them.
Explains the dry running protection, error indication, and restart attempts.
Describes the anti-leakage function, its conditions for activation, and error indication.
Explains the maximum operating time function, its conditions for activation, and its purpose.
Details the pressure sensor alarm, its activation conditions, and how it resets.
Covers the initial LED test sequence and the pump's behavior during the first priming phase.
Explains the pump's operational behavior when the CUT-OUT function is disabled.
Explains the pump's operational behavior when the CUT-OUT function is enabled (factory setting).
Ensures no water residue remains to prevent freezing and damage to plastic parts.
Step-by-step instructions for cleaning the pump's suction filter, including necessary precautions.
Procedure for cleaning the Non-Return Valve (NRV) using the provided accessory.
Provides a table of common faults, their possible causes, and recommended remedies.
Instructions on how to fill the expansion vessel with air to the correct pressure.
Details the legal guarantee terms, conditions for replacement, and parts not covered.
To Next Page
