TAMBU 20210303 - Inner Tent Setup; Frame Assembly and Tensioning; Attach Inner Tent Straps; Outer Tent Placement

22
SETUP
Figure 1:
1. Remove the tent, the fiberglass poles (C) and the pegs (D) from the
retail pack.
2. Lay the inner tent (A) flat and completely unfolded on the ground
where it is to be pitched. The openings for the poles (C) must be
on the outside of the Tent.
3. Unpack the poles (C) and assembly the individual parts together
one at a time.
4. Carefully guide the poles (C) through the openings to the end of
each side of the tent.
5. Fasten each of the 4 corners of the inner Tent to the ground using
the pegs (D).
Figure 2:
6. Lift the poles (C), bend them and put the respective end into the
metal eyelets. The frame is now set up and under tension. Beware
of over-tensioning. If the tension is too high, the tent may tear.
7. Attach the central loop of the inner tent (A) to the upper part of
the frame (C).
Figure 3:
8. Attach the straps of the inner tent (A) to the poles (C).
Figure 4:
9. Place the outer tent (B) on top of the inner tent construction. Make
sure it is centered and that the entrances are on top of each other.
10. Connect the outer tent (B) to the inner tent construction by using
the Velcro tape.
11. Attach the hooks of the outer tent (B) to the metal eyelets of the
inner tent.
ENG
GAMBUJA 3 Person Dome Tent | © Tambu Outdoor GmbH