28
SETUP | DISMOUNTING
Figure 3:
8. Fix the anchoring points of the whole construction by using the
tent pegs (F).
Figure 4:
9. Hang the sleeping cabins (B) onto the plastic clips in the designa-
ted areas of the tent.
10. Attach the sleeping cabins to the sewn-in floor of the tent using
the plastic buckles.
Figure 5:
11. Secure the guide ropes to the ground with tent pegs (F).
Figure 6:
12. Place the outer points of the tent canopy onto the awning poles (E)
13. Fasten the guide ropes of the tent canopy each with a tent peg (F)
in the ground so that the construction is under tension.
14. You can now use the tent.
Dismounting the tent
Clean the inside and outside of the tent before dismounting it. Dismoun-
ting the tent must be done in reverse order to the setup of the tent.
Packing the tent
Make sure the tent is completely dry before packing it up. Failure to do so
may result in stains and fabric damage.
Caution!
Make sure that you pack the pegs (F) and (G) separately in the pockets
provided (I). Otherwise the pegs (F) and (G) could damage the tent. Also
!
BARA 4 Person Family Tent | © Tambu Outdoor GmbH
To Next Page
Loading...