21. Using the Black Magic Marker, coat the end of the hatch pin, install hatch,
pull back and release striking the fuselage identifying the location of the pin. Drill
a 1/16” hole at this location. Repeat for both latches.
21. Locate a hole in each FRONT corner of the Main Hatch for the mounting of
the brass tube pins. Epoxy the pins into each hole allowing ¼” to stick out. Allow
to cure. (NOTE: Carbon Fiber Pins can be substituted for the supplied Brass
Pins)
22. Now transfer the location of the pins to the fuselage as shown, then drill to
accept the pins. This completes the Main Hatch Installation.
To Next Page
