BEGIN CONSTRUCTION:
FUSELAGE:
1. Locate all plywood components that will be fitting into the Nose cone. Trial
fit all parts together and LIGHTLY sanding any part that may cause the
fiberglass to “BULDGE” as we do not want this tight a fit as we must allow
for the glue joint as well. The TRAY is to remain REMOVABLE !
2. When satisfied with all fits, sand the fiberglass in the areas of the glue joints
and proceed to tact glue bulkheads into place and finish with a bead of Hysol
9462. Allow to cure overnight at room temperature
To Next Page
Loading...
