Tamjets F-16 - Page 17

Tamjets F-16 Instruction Manual
Use M3 x 25mm screw supplied with the hardware to tap the hole. Put a few drops of
thin CA to harden the balsa inside the rudder after tapping the hole.
Place one drop of thin CA on the screw thread then tighten in the screw. Leave 3/8”of the
screw socket head sticking out. The 3/8” is measured from the rudder surface to the base
of the socket head screw.
www.tamjets.com 408-224-7600 17of64