6
MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning
before use.
It is important that you read, fully
understand and observe the
following safety precautions and
warnings.
Careless or improper use of the unit
may cause serious or fatal injury.
Shows maximum shaft speed. Do
not use the cutting attachment
whose max speed is below the
shaft speed.
Read, understand and follow all
warnings and instructions in this
manual and on the unit.
Gloves should be worn
when necessary, e.g., when
assembling cutting equipment.
Always wear eye, head and ear
protectors when using this unit.
Use anti-slip and sturdy footwear.
Keep all children, bystanders and
helpers 15 m away from the unit.
If anyone approaches you, stop
the engine and cutting attachment
immediately.
Blade thrust may occur when
the spinning blade contacts a
solid object in the critical area.
A dangerous reaction may occur
causing the entire unit and
operator to be thrust violently.
This reaction is called blade
thrust. As a result, the operator
may lose control of the unit which
may cause serious or fatal injury.
Blade thrust is more likely to
occur in areas where it is diffi cult
to see the material to be cut.
Be careful of thrown objects.
Be careful of the engine.
Engine gets hot by running engine.
Indicate handle location. Do not
attach handle above this point.
Contents
WHAT IS WHAT .................................................................7
WARNINGS AND SAFETY INSTRUCTIONS ....................8
SPECI FI CATIONS .............................................................. 9
ASSEMBLY PROCEDURES ............................................ 10
OPERATING PROCEDURES .......................................... 11
MAINTENANCE ............................................................... 12
000BookTCG31EBSTha.indb6000BookTCG31EBSTha.indb6 2010/02/2318:47:092010/02/2318:47:09
To Next Page
Loading...
