Need help?Do you have a question about the TANDBERG 64 and is the answer not in the manual?
Includes power switch, tape counter, speed selector, operating lever, and start-stop button.
Covers record/playback push-buttons, gain controls, level indicators, and volume controls.
Details microphone inputs and the sound-on-sound switch.
Covers trim covers for access and the automatic end stop function.
Description of input/output jacks and remote control connector.
Description of input/output jacks for FM-Multiplex models.
Details the operating lever's function and adjustments.
Explains the function of the eccentric segment and trip bar.
Guides the pressure wheel for tape motion.
Adjusts the tape brake for proper disengagement.
Covers muting switch connection and trip bar function.
Details the supply and take-up turntable assemblies.
Procedures for horizontal and vertical turntable alignment.
Covers general clutch operation and adjustments.
Details the motor pulley, its tracks, and drive belt threading.
Description of the speed transfer wheel mechanism.
Covers lifting mechanism and flywheel brake adjustments.
Details speed change mechanism and momentary start-stop.
Covers pressure pad function and automatic end stop switch.
Details revolution counter and top cover assembly.
Block diagram of the tape recorder's electronic units.
Description and schematic of the record pre-amplifier.
Details the FM-multiplex filter circuit.
Description and schematic of the record amplifier.
Description and schematic of the playback pre-amplifier.
Details the cathode follower and record level indicator circuits.
Description of oscillator, bias, and erase circuits.
Schematic of the momentary start-stop circuit.
Schematic and description of the power supply.
Block diagram of the tape recorder's switching system.
Covers monaural, stereo, mixing, and track adding.
Procedures for monaural and stereo playback.
Techniques for adding sound and creating echo effects.
Methods for head alignment with and without test tapes.
Track control for Model 64 and Model 62.
Details adjustments for coils, bias, recording current, and filters.
Tests for playback/record amplifiers and overall response.
Details Model 64 to 62 modification and ECC81 tube intro.
List of mechanical components with reference numbers.
List of resistors, screws, coils, tubes, rectifiers, and fuses.
List of capacitors with specifications.
Lubrication instructions for the Papst motor.
Lubrication instructions for the Engel motor.
Lubrication advice for self-lubricating bearings.
To Next Page
General