Tandy TRS-80 4D - Page 19

Tab
E
When the write-protect notch
is covered,
you
cannot change the
contents of this
master
diskette. In the next
chapter, we'll have
you
make copies of the
master diskette.
Starting
Up TRSDOS
Insert
the TRSDOS and
BASIC Interpreter
diskette
into Drive
as
shown
below. (Note:
If
the
"Diskette?"
message
is
displayed, the
drive
light
stays
on. Insert
the diskette any-
way.)
Be sure the label faces
up
and
the read/
write window
points into
the
drive.
After fully
inserting
the diskette, close the drive
door
by
turning
the
latch
down, over the
drive opening.
Read/Write
Window
Label
Reset
Note: The drive
latch
is
designed
so
that
it can
be
turned only
when the drive con-
tains
a
diskette.