9
USER MANUAL
THE
Di5a
SYSTEM
Frequency Response (-3dB)
(1)
100Hz – 25kHz
Frequency Range (-10dB)
(1)
90Hz – 30kHz
Dispersion 90
Degrees conical -6dB
Low Frequency Driver 1x 110mm (4.50”)
Mineral loaded polypropylene
High Frequency Driver 25mm (0.98”)
ICT
TM
Crossover 7kHz
Inductively Coupled ICT
TM
Directivity Factor (Q) 1kHz to 10kHz 5.3 averaged
Directivity Index (DI) 1kHz to 10kHz 6.6 averaged
Rated Maximum SPL
(2)
Average 103dB
Peak 109dB
Power Output 30W RMS
Distortion 10% Full Power (4.25V) 2nd Harmonic 3rd Harmonic
250Hz 1.33% 0.25%
1kHz 0.62% 0.16%
10kHz 1.43% 0.35%
Distortion 1% Full Power (1.34V) 2nd Harmonic 3rd Harmonic
250Hz 0.41% 0.10%
1kHz 0.23% 0.07%
10kHz 0.32% 0.18%
Input Sensitivity (for maximum input) 775mV (balanced)
500mV (unbalanced)
Input Impedance (for maximum input) 11k Ohm (balanced)
7k Ohm (unbalanced)
Protection Circuitry Thermal
Soft Limiting
Supply 100 - 240V AC, 50 – 60Hz
Fuse T1AL 250V
Power Consumption 76VA maximum
CONSTRUCTION
Enclosure High impact polystyrene (HIPS)
Grille Powder coated steel
Finish Textured black or white paint with matching rubber trims
Factory fitted custom trim colours available to special order
Connectors 6 way euro-type input / output connector
Unbalanced RCA (phono) input
Mains inlet IEC type C13
Dimensions (H x W x D) 240.7 x 155.0 x 162.0mm
9.47 x 6.10 x 6.38”
Weight 2.40kg (5.3lbs)
Notes:
(1) Average over stated bandwidth. Measured at 1 metre on axis in an anechoic chamber
(2) Unweighted pink noise input, measured at 1 metre in an anechoic chamber
A full range of measurements, performance data, and Ease
TM
Data can be downloaded from www.tannoy.com
Tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing methods will always equal or exceed the published specifications,
which Tannoy reserves the right to alter without prior notice.
To Next Page
Loading...
