Tannoy United Kingdom
Tannoy North America
Tannoy Deutschland
Tannoy France
T: 00 44 (0) 1236 420199
T: 00 1 (519) 745 1158
T: 00 49 (180) 1111 881
T: 00 33 (0)1 7036 7473
E: enquiries@tannoy.com
E: inquiries@tannoyna.com
E: anfragen@tannoy.com
E: ventes@tannoy.com
iw62 TDC
Tannoy adopts a policy of continuous improvement and product specification is subject to change
iW62TDC data file issue:1.06 // 15.01.08
T
he in wall speaker shall consist of one 165mm (6.50") Dual Concentric™ full range transducer, one 25mm (1.00”) SuperTweeter™ and one 165mm (6.50")
b
ass driver, mounted in an injection moulded front baffle manufactured from UV/weather resistant UL94V-0 ABS material. The three-way system shall
i
ncorporate an optimised low loss crossover network. The wiring terminals shall be gold plated spring loaded connectors.
Performance of the in-wall speaker shall meet or exceed the following criteria: The system shall have a coverage angle of 120 degrees (1kHz to 6kHz).
Frequency response measured on axis shall be 34Hz - 54kHz (-10dB from rated sensitivity, measured in an IEC baffle in an anechoic chamber) with no
equalization. Sensitivity shall be 92dB (1W @ 1m). Long term power handling capacity as defined in EIA-426B test shall be 105W, recommended amplifier
power 220W @ 8 Ohms. The nominal system impedance shall be 8 Ohms.
In 70V or 100V distributed audio systems the iw62 TDC can be used with the optional the THP60 high performance, low insertion loss transformer with 60,
30, 15 and 7.5W taps* available. A weather resistant perforated steel grille covers the transducer. Both the grille and baffle shall be paintable.
T
he system shall not exceed the following dimensions: 473.50 x 227 or 18.64 x 8.94 (H x W).
H
ole cut out size shall be 426.10 x 187.6mm or 16.76 x 7.39"
The in wall speaker system shall be the.....iw62 TDC.
*70.7 Volt only
Architectural specifications
To Next Page
Loading...
