Tannoy OCV Series - Page 5

18
OCV Series OCV 8 / OCV 6 Quick Start Guide
19
Installation Guide
1. Inspect cable clamp for signs of
dirt, damage or wear.
2. Insert cable through one
side of the clamp.
3. Loop cable around suspension
point and then into the other
side of the clamp.
Repeat 1-3 for secondary
safety attachment.
4. Adjust cable to the
desired length.
5. Release cable by depressing
the clamp sockets as shown.
6. Attach the hanging cable to
the centre hole of the speaker bracket.
The safety cable can be attached to
either of the secondary holes.
HANGING / SAFETY POINT
TAP SELECT
OR
EUROBLOCK