Power / Filter Reset Button
Press to turn on / off the unit, the LED light and corresponding mode indicators
will turn on / off. The FILTER RESET indicator will turn on red to remind you to
change the f ilter, press and hold the POWER / FILTER RESET Button for 5
seconds to turn off the LED indicator. Change the f ilter, turn on the purif ier again
to start working normally.
Light Button
When the purif ier is on, press to adjust 3 levels of the LED light brightness.
Note:
Refer to “Installing and Removing the Filter” part for more information
about the f ilter reset function.
Note: In Sleep mode, only the SLEEP button indicator will stay on, and
the unit will run in low speed.
Fan Speed Button
Press to adjust the fan speed when the unit is in operation and cycle through
LOW I / MEDIUM II / HIGH III / TURBO settings.
Note:
• In turbo mode, all the three FAN SPEED LED indicators will turn on.
• When the unit is not in use, please switch it off and unplug from power.
Sleep Button
When the purif ier is on, press to activate SLEEP mode.
EN EN
07
09 11
13 15 17 19 21 23
25
27 29 31 33 35 37
39 41 43 45 47 49
51 53 55 57 59 61
02 04 06
08
10 12
14 16 18 20 22 24
26
28 30 32 34 36 38
40 42 44 46 48 50
52 54 56 58 60 62
To Next Page
Loading...
Need help?
General
