Tapco Max Snap Stand User Manual

Max Snap Stand
™
Item # 11957
T4043 7/04
29797 Beck Road • Wixom, MI 48393-2834
phone: (800) 521-7567 • www.tapcoint.com
TAPCO PRODUCTS COMPANY
A Division of Tapco International
Operating Instructions
©2004 Tapco International Corporation
S n a p S t a n d
S n a p S t a n d
M a x S n a p S t a n d
Counter Balance Assembly Instructions
4
Contents
Setting up your
Max Snap Stand .................. 2
Installing a Brake on your
Max Snap Stand ...............2-3
Removing Brake from
Max Snap Stand .................. 3
Counter Balance Step
Assembly Instructions ........ 4
Removal is the reverse of assembly. Lift up on the steps to release them from the
legs, and slide the assembly to the right until the connectors are free of the legs.
STEP 1
Attach the Connectors to the Steps using the carriage bolts and nuts provided. The square
portion of the carriage bolt will fall into the square holes that are punched in the Connector.
Tighten securely using a 7/16" wrench. See figure 5 above for Connector orientation.
Connector
STEP 2
To attach the Step Assembly to the Snap Stand, hold the assembly at an angle as shown and slide both
connectors leftward over both legs of the Snap Stand as far as they will go. Allow the connectors to slip
down the legs until the steps are fl at and touching the ground. The connectors should be gripping the front
and back of each leg. Standing on the steps while bending will lock the connectors in place on the legs.
Step
TOP
UNDERSIDE
Figure 5
Figure 5
T4043 Max Snap Stand Inst.indd 2-3 8/18/04 2:32:35 PM

Tapco Max Snap Stand Specifications

General

Brand	Tapco
Model	Max Snap Stand
Category	Racks & Stands
Language	English

Summary

Max Snap Stand Setup

Open Leg Sets

Open leg sets by pushing snap button and extending legs to working position until locked.

Attach Cross Braces

Connect cross braces to leg sets, ensuring proper C-shape mating with the legs.

Max Snap Stand Brake Installation

Fasten Brake Mounts

Secure brake mounting brackets to the leg sets using provided bolts and washers.

Repeat Brake Installation

Repeat brake mount installation for the other leg set, ensuring correct orientation.

Install Max Brake on Snap Stand

Position Brake on Stand

Place the brake on the stand, ensuring the back rail clears the adaptor hook.

Secure Brake to Stand

Push brake rearward until snap buttons pop up, securing it to the stand.

Remove Brake from Snap Stand

Counter Balance Assembly Instructions

Attach Connectors to Steps

Connect connectors to steps using carriage bolts and nuts, tightening securely.

Attach Step Assembly to Stand

Slide connectors over legs, lower to ground, and stand on steps to lock connectors.