Need help?Do you have a question about the Taramps THE BIG BOSS 3 BASS and is the answer not in the manual?
General| Number of Channels | 1 |
|---|---|
| Operating Class | D |
| Input Sensitivity | 300mV |
| Signal to Noise Ratio | >90dB |
| Bass Boost | 0 to 10dB (50Hz) |
| Input Impedance | 10K OHMS |
| Output Impedance | 0.5 OHM |
| Minimum Supply Voltage | 9 VDC |
| Maximum Supply Voltage | 16 VDC |
| Maximum Power @ 12.6 VDC - 0.5 OHM | 3000W |
| Frequency Response | 10Hz - 250Hz |
| Crossover Low Pass (LPF) | 50Hz - 250Hz |
| Crossover High Pass (HPF) | 10Hz - 80Hz |
| Protection System | Short on output, low/high voltage, thermal protection |
Amplifier automatically restarts after a protection event is triggered.
Covers installation, electrical, placement, wiring, sound, and disposal safety for amplifier use.
Connects to the positive battery terminal with a fuse or circuit breaker (200A).
Connects to the negative battery pole using a short, 4 AWG to 1/0 AWG cable.
Red LED flashes 2x for battery voltage below 9V.
Red LED flashes 3x for battery voltage above 17V.
Red LED flashes 6x per second for short circuit or ground connection.
Yellow LED flashes 1 sec. on/off when temperature exceeds operating limit (>85°C).
Specifies wire gauges (4 AWG to 1/0 AWG), remote cable (18 AWG), and fuse (200A).
Avoid power loss/overheating with proper gauges, check polarity, use fuse/breaker near battery.
Illustrates connections for power, remote, speakers, head unit, and other amplifiers.
Delivers 3000W RMS power at 0.5, 1, and 2 Ohms, and 1700W RMS at 4 Ohms.
Includes output short-circuit, voltage, and thermal protection.
To Next Page
